Category:Full automatic positive pressure thermoforming mac;Model:RJD-600*720 LX-5
RJD-515 × 580LX-5/600 × 720LX-5 positive pressure molding, heating, blanking, stacking line unit, is a machine, electricity, gas, integration design, PLC programmable control system, microcomputer control, servo motor drive, sheet feeding, manipulator stacking, man-machine interface operation, the product is sheet feeding, heating, molding, trimming, stacking four positions in a production line, the utility model has the advantages of simple operation, low power consumption, high speed, accurate punching positioning and labor-saving plastic sheet thermoforming equipment. With manual, semi-automatic, fully automatic operation of three functions. It adopts original semi-automatic die forming, laser blade blanking, low die cost, short production cycle and so on. At the same time, it can produce the products of punching and flanging. The average product cycle is 2-6 seconds.
Maximum forming height |
100mm |
120mm |
Sheet thickness range |
0.1-1mm |
0.1-1mm |
Maximum roll diameter |
710mm |
1000mm |
Air flow |
2.5m3/min |
3m3/min |
Heating plate power |
15Kw |
18Kw |
Formwork heater power |
4.8Kw |
6Kw |
Air pressure |
0..8Mpa |
0..8Mpa |
Water consumption |
10(Liters/min)(10-20°C) |
10(Liters/min)(10-20°C) |
Power source |
3-NAC380V±1.5V |
3-NAC380V±1.5V |
Production rate |
480-1300(Cycles/hr) |
480-1300(Cycles/hr) |
Overall dimensions of equipment |
(L)6400*(W)1050*(H)2400 |
(L)7200*(W)1350*(H)2400 |
Equipment weight |
4300Kg |
4500Kg |
Maximum atmospheric discharge |
2m3 |
2.5m3 |